When replacing engine oil filter, change engine oil at the same time.ġ.Engine oil should be changed while engine is warm.Replace initially after 20 hours (1 month) and every 200 hours (12 months). This section describes servicing procedures for each of periodic maintenance requirements.ĮNGINE OIL / ENGINE OIL FILTER ENGINE OIL LEVEL CHECKĮNGINE OIL CHANGE / ENGINE OIL FILTER REPLACEMENT ENGINE OILĬhange initially after 20 hours (1 month) and every 100 hours (6 months). If level is low, add recommended oil to full level hole (Max.). Oil level should be between full level hole (Max.) and low level hole (Min.). Insert it fully into dipstick hole, then remove it to check oil level.ĥ. Remove oil level dipstick and wipe it clean.Ĥ. Place mercury 40hp manual outboard motor upright on a level surface.ģ. NOTE: More frequent servicing should be performed on outboard motors that are used under severe conditions.ġ. ![]() Maintenance intervals should be judged by number of hours or months, whichever comes first. The chart below lists the recommended intervals for all the required periodic service work necessary to keep the motor operating at peak performance and economy. PRE-PROGRAMMED VALUE FOR FAIL-SAFE SYSTEMįUEL VAPOR SEPARATOR / HIGH PRESSURE FUEL PUMP PRIORITY / CODE / PATTERN FOR SELF-DIAGNOSTICĬONDITION FOR SELF-DIAGNOSTIC SYSTEM OPERATION
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |